[PDF&VCE] Latest 400-101 Dumps PDF Free Download In Lead2pass 100% 400-101 Pass Guaranteed (726-750)
2016 October Cisco Official New Released 400-101 Dumps in Lead2pass.com! 100% Free Download! 100% Pass Guaranteed! Lead2pass 400-101 latest updated braindumps including all new added 400-101 exam questions from exam center which guarantees you can 100% success 400-101 exam in your first try! Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/400-101.html QUESTION 726
Drag and Drop Question
Drag and drop each policy command on the left to the function it performs on the right. 
Answer:
QUESTION 727
Which topology allows the split-horizon rule to be safely disabled when using EIGRP? A. full mesh
B. partial mesh
C. hub and spoke
D. ring Answer: C
QUESTION 728
Which two statements about VPLS are true? (Choose two.) A. Split horizon is used on PE devices to prevent loops.
B. Spanning tree is extended from CE to CE.
C. IP is used to switch Ethernet frames between sites.
D. PE routers dynamically associate to peers.
E. VPLS extends a Layer 2 broadcast domain. Answer: AE QUESTION 729
Which two statements about redistribution are true? (Choose two.) A. When BGP traffic is redistributed into OSPF, the metric is set to 1 unless the metric is defined.
B. When EIGRP routes on a CE are redistributed through a PE into BGP, the Cost Community POI is set automatically.
C. When OSPF traffic is redistributed into BGP, internal and external routes are redistributed.
D. When BGP traffic is redistributed into OSPF, eBGP and iBGP routes are advertised.
E. iBGP routes automatically redistribute into the IGP if the routes are in the routing table.
F. When EIGRP traffic is redistributed into BGP, a default metric is required. Answer: AB QUESTION 730
Refer to the exhibit. The two standalone chassis are unable to convert into a VSS. What can you do to correct the problem?
 A. Set a different port channel number on each chassis.
B. Set a different virtual domain ID on each chassis.
C. Set the redundancy mode to rpr on both chassis.
D. Add two ports to the port channel group. Answer: A QUESTION 731
Drag and Drop Question
Drag and drop each MLPPP command on the left to the function it performs on the right.
Answer:
 QUESTION 732
Which three address family types does EIGRP support? (Choose three.) A. IPv4 unicast
B. IPv4 multicast
C. IPv6 unicast
D. IPv6 multicast
E. IPv4 anycast
F. IPv6 anycast Answer: ABC QUESTION 733
Which two values must be identical to allow IS-IS devices to become neighbors? (Choose two.) A. interface MTU
B. authentication key
C. IP MTU
D. CLNS address
E. NSEL
F. area ID Answer: AB QUESTION 734
Which Layer 2 tunneling technique eliminates the need for pseudowires? A. OTV
B. L2TPv3
C. AToM
D. VPLS Answer: A QUESTION 735
Which two application protocols require application layer gateway support when using NAT on a Cisco router? (Choose two.) A. SIP
B. HTTP
C. FTP
D. SMTP
E. POP3 Answer: AC QUESTION 736
Which three options must be configured when deploying OSPFv3 for authentication? (Choose three.) A. security parameter index
B. crypto map
C. authentication method
D. IPsec peer
E. encryption algorithm
F. encryption key
G. IPsec transform-set
H. authentication key Answer: ACH QUESTION 737
Which two statements about IOS and IOS XE are true? (Choose two.) A. IOS XE can upgrade and restart applications independently of IOS.
B. Only IOS uses the FFM to provide separation between the control plane and the data plane.
C. IOS XE provides improved functionality and an enhanced UI.
D. Only IOS runs as a single daemon within the Linux OS.
E. IOS XE provides additional system functions that run as multiple separate processes in the OS. Answer: AE QUESTION 738
An NSSA area has two ABRs connected to Area 0. Which statement is true? A. Both ABRs translate Type-7 LSAs to Type-5 LSAs.
B. The ABR with the highest router ID translates Type-7 LSAs to Type-5 LSAs.
C. Both ABRs forward Type-5 LSAs from the NSSA area to backbone area.
D. No LSA translation is needed. Answer: B QUESTION 739
Which two options are requirements to implement 6VPE? (Choose two.) A. MPLS between PEs
B. 6-in-4 tunnels between PEs
C. MP-BGP VPNv6 exchange
D. MP-BGP IPv6+label exchange
E. Any Transport over MPLS
F. IPv4/IPv6 dual-stack in core Answer: AC QUESTION 740
Refer to the exhibit. All routers are running EIGRP and the network has converged. R3 and R4 are configured as EIGRP Stub. if the link between R1 and R3 goes down, which statement is true?
 A. R1 sends traffic destined to 192.168.0.100 via R2.
B. R2 does not have a route to 192.168.0.0/24 in the routing table.
C. The prefix 192.168.0.0/24 becomes stuck-in-active on R4.
D. R3 does not advertise 192.168.0.0/24 to R4 anymore. Answer: B QUESTION 741
Which three options are characteristics of a Type 10 LSA? (Choose three.) A. It is an area-local, opaque LSA.
B. Data is flooded to all routers in the LSA scope.
C. It is used for traffic-engineering extensions to OSPF.
D. It is a link-local, opaque LSA.
E. Data is flooded only to the routers in the LSA scope that understand the data.
F. It is used for traffic-engineering extensions to LDP. Answer: ABC QUESTION 742
Drag and Drop Question
Drag each SNMP term on the left to the matching definition on the right.
Answer:
 QUESTION 743
Refer to the exhibit. Which two statements about this capture are true? (Choose two.)
 A. It is set to run for five minutes.
B. It continues to capture data after the buffer is full.
C. It is set to run for a period of 00:03:26.
D. It captures data only until the buffer is full.
E. It is set to use the default buffer type. Answer: AB QUESTION 744
Drag and Drop Question
Drag each AF class on the left to its matching DSCP binary value on the right.
Answer:
 QUESTION 745
Which three types of address-family configurations are supported in EIGRP named mode? (Choose three.) A. address-family ipv4 unicast
B. address-family vpnv4
C. address-family ipv6 unicast
D. address-family ipv6 multicast
E. address-family vpnv6
F. address-family ipv4 multicast Answer: ACF QUESTION 746
Refer to the exhibit. Which three statements about the device with this configuration are true? (Choose three.)
 A. Multiple AFIs are configured on the device.
B. The authentication on 172.16.129.7 is configured incorrectly.
C. The device is configured to support MPLS VPNs.
D. This device is configured with a single AFI.
E. The authentication on 172.16.129.4 is configured incorrectly.
F. The device is configured to support L2VPNs. Answer: ABC QUESTION 747
Refer to the exhibit. Which configuration must you apply to router R2 to enable BFD?
 A.
B.
C.
D. Answer: A QUESTION 748
Which two options about PIM-DM are true? (Choose two.) A. PIM-DM initally floods multicast traffic throughout the network.
B. In a PIM-DM network, routers that have no upstream neighbors prune back unwanted traffic.
C. PIM-DM supports only shared trees.
D. PIM-DM uses a pull model to deliver multicast traffic.
E. PIM-DM cannot be used to build a shared distribution tree. Answer: AE QUESTION 749
Drag and Drop Question
Drag each GETVPN component on the left to its function on the right.
Answer:
 QUESTION 750
Which two statements about EIGRP load balancing are true? (Choose two.) A. EIGRP supports 6 unequal-cost paths.
B. A path can be used for load balancing only if it is a feasible successor.
C. EIGRP supports unequal-cost paths by default.
D. Any path in the EIGRP topology table can be used for unequal-cost load balancing.
E. Cisco Express Forwarding is required to load-balance across interfaces. Answer: AB Lead2pass regular updates of Cisco 400-101 dumps, with accurate answers, keeps the members one step ahead in the real 400-101 exam. The experts with more than 10 years experience in Certification Field work with us. 400-101 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDU2RjeUlHTTZXb1U 2016 Cisco 400-101 exam dumps (All 1219 Q&As) from Lead2pass: http://www.lead2pass.com/400-101.html [100% Exam Pass Guaranteed]
|
