[May 2018] Quickly Pass 210-065 Test With Lead2pass New 210-065 Brain Dumps 354q

Try Lead2pass Latest Cisco 210-065 Dumps To Pass The Exam Successfully:

https://www.lead2pass.com/210-065.html ^{2 1}

QUESTION 21
Which CLI command can be used to reset the Cisco TelePresence System 500-32 personal video system to a factory condition?

A.    utils factory reset 2
B.    utils system factory init
C.    xcommand defaultvalues set level: 2
D.    xconfiguration default factory
E.    utils reset factory
F.    xcommand SystemUnit FactoryReset

Answer: B

QUESTION 22
The C-Series endpoint (codec) does not register with the Video Communication Server that is located in a different network. Based on the exhibits, what could be causing the issue?

A.    The subnet mask on the codec is incorrect.
B.    The ip address of the codec is incorrect.
C.    The interface that the codec is in is in the wrong VLAN.
D.    The codec did not receive a DHCP address from the DHCP server.

Answer: A
Explanation:
The subnet mask configured on the codec is 255.255.255.128, when it should be 255.255.255.0.

QUESTION 23
Which three of these are functions of the Cisco TelePresence Management Suite? (Choose three.)

A.    automatic software update and release keys
B.    intelligent call routing engine
C.    provisioning a Cisco TelePresence System endpoint
D.    tracing SIP and H.323 calls
E.    managing phonebooks for endpoints that are registered to the Cisco Unified Cisco Unified Communications Manager
F.    rebooting endpoints that are registered to the Cisco TelePresence Video Communications
Server

Answer: ABF

QUESTION 24
Refer to the exhibit. Which system tab can be used to add video infrastructure devices and endpoints?

A.    Navigator
B.    System Overview
C.    Configuration Templates
D.    Provisioning
E.    Administrative Tools

Answer: A

QUESTION 25
Which two layout or switching modes are supported with the Cisco TelePresence Multipoint Switch? (Choose two.)

A.    enhanced continuous presence
B.    active speaker switching
C.    continuous presence
D.    speaker switching
E.    room switching
F.    active continuous presence

Answer: DE

QUESTION 26
Which Cisco TelePresence Multipoint Control Unit Layout view mode gives prominence to one conference participant over the other conference participants while still allowing conference participants to view multiple participants at the same time?

A.    enhanced continuous presence
B.    active speaker
C.    continuous presence
D.    room switching
E.    speaker switching

Answer: A

210-065 dumps full version (PDF&VCE): https://www.lead2pass.com/210-065.html ^{2 1}

Large amount of free 210-065 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDTERGM2szMlVfSTQ ³

You may also need:

210-060 exam dumps: https://drive.google.com/open?id=0B3Syig5i8gpDN25QVlRta3F0UkE ⁴

1. https://www.lead2pass.com/210-065.html
2. https://www.lead2pass.com/210-065.html
3. https://drive.google.com/open?id=0B3Syig5i8gpDTERG M2szMlVfSTQ
4. https://drive.google.com/open?id=0B3Syig5i8gpDN25Q VlRta3F0UkE