Section 4 – Cisco Unified Communications Manager

QUESTION 1
An administrator wants to locate and remove all unassigned directory numbers on the Cisco Unified Communications Manager system. Which method is the best method to accomplish this task?
A.    Choose Device > Phone. Search all phones and remove the undesired directory numbers.
B.    Use the Dial Plan Installer to remove the directory numbers.
C.    Use the Disaster Recovery System to restore only valid directory numbers.
D.    Choose Call Routing > Route Plan Report, choose the Unassigned DN drop-down menu, and then
remove all orphaned directory numbers.
E.    Choose Device > Device Settings > Device Defaults and use the wizard to locate and remove the
orphaned directory numbers.
Answer: D

QUESTION 2
How does the Cisco Unified Communications Manager Express match an outbound VoIP dial peer?
A.    Outbound dial-peer matching uses the entire string of digits en bloc to match the dial peer with
the longest match.
B.    Outbound dial-peer matching is completed on a digit-by-digit basis.
C.    It matches outbound dial peers by placing all the dial peers into a hunt group and then uses the
entire dialed number en bloc to match the first dial peer.
D.    Cisco Unified Communications Manager Express creates a hunt group that contains all the
configured dial peers and then applies the dial digits in a digit-by-digit manner to match a dial peer.
Answer: A

QUESTION 3
In which situation are user PINs maintained by the local Cisco Unified Communications servers?
A.    Only when the system is using LDAP synchronization.
B.    Only when the system is using LDAP authentication.
C.    Only when the system is using Global Directory.
D.    PINs are always maintained by the local Cisco Unified Communications Manager servers
E.    PINs are never maintained by the local Cisco Unified Communications Manager servers.
Answer: D

QUESTION 4
Which command is used to determine if an MGCP gateway is registered with a Cisco Unified Communications Manager server?
A.    show gateway status
B.    show isdn q931
C.    show ccm-manager
D.    show isdn status
E.    show isdn q921
Answer: C

QUESTION 5
An administrator is attempting to add a new user in Cisco Unified Communications Manager Administration but does not see the option to add a new user. What is the most likely cause of this issue?
A.    The SQL User database is not running.
B.    The system is synchronized with an LDAP server.
C.    BAT is not enabled.
D.    The administrator hasthe aceno user adda rights box checked.
E.    The SIP Realm is not defined in User Management.
Answer: B